GENERAL
MOUNTING INSTRUCTIONS
Assembly is very easy: it takes
no more than five minutes and you're ready to have fun with your dog,
in complete safety and with both your hands tightly holding the
handlebars.
1) |
After opening the packaging, separate the two parts of the fixing jaw (7 and 8) from the tubular bar (5); |
2) |
Position
the two parts of the fixing jaw on the saddle-holding pole, slightly
tightening the screws (9). (Allow the jaw to stay in position but still
free to be adjusted); |
3) |
In
case of non-standard seat post diameter (or simply to avoid scratches)
wrap the rubber band (6) around the post before positioning the jaw. |
4) |
Hook up the tubular bar (5), orienting it towards the back of the bike at an angle of about 20°. |
5) |
Now,just tighten the screws firmly, and you are ready to go. |
6) |
Make sure the quick-lock (11) is completely engaged. |
Adjusting the product:
The cord length can be adjusted by regulating the number of springs in
the internal shock-absorbing system. By reducing the number of springs,
the cord becomes lengthened and the spring tension is reduced, thus
adapting the WalkyDog® to small sized dogs. The internal spring system
can be accessed by unscrewing the front bullet terminal (3) and
removing the cord (2). Undo the spring holding knot on the cord's end
and remove one or two springs; tie the knot on the end of the cord
again before re-inserting the system inside the tubular bar.
See Below for General Adjustment Suggestions:
- Use
3 springs for adult dogs such as Alaskan Malamutes, Dobermans and the
like; Use 2 springs for adult dogs such as Siberian Husky, Golden
Retriever, Dalmatians, German Shepherds and the like;
- Use 1 spring for puppies of the above-mentioned breeds and generally for small sized dogs.
Troubleshooting:
Problem: The fixing jaw loses its grip
Solution: Every now and then, just make sure the jaw's screws are firmly tightened.
Problem: The cord is too short/long for the dog
Solution: Adjust the number of internal springs until the desired length is achieved.
Problem: The cord has begun to fray
Solution:
Our cords are specially selected for use with the WalkyDog®.
Nevertheless, due to specific use conditions/dog behaviour they can
deteriorate (nothing lasts forever!). Replace them: any similary shaped
cord with the same diameter will do the trick. Now you're ready to have fun with your dog, in complete safety and with both your hands tightly holding the handlebars!
Pay careful attention to regulate the intensity, length and speed of
each training session to the fitness and health condition of your dog.
Once your bike is parked, simply disengage the WalkyDog and use it as a comfortable leash!
Click to download a video:
|
|
|
|
|
Download
(Zip - 1.7 Mb) |
Download
(Zip - 2.5 Mb) |
Download
(Zip - 1.7 Mb) |
Download
(Zip - 2.3 Mb) |
IMPORTANT NOTE AND LEGAL DISCLAIMER
The WalkyDog® should not be used by children younger than 15 years of
age or with a body weight lighter than 80 pounds. Strict parental
supervision of children using the WalkyDog® is strongly recommended.
The WalkyDog® should not be used by riders carrying children on the
bike.
The WalkyDog® is a product specifically designed for the professional
endurance training of competition dogs. Before using the product on any
public road, carefully check the Highway Code.
WalkyDogUSA.com shall not be liable (contractual, tortious or
otherwise) to users of the WalkyDog® with respect to any loss or damage
(including, without limitation, consequential loss or damage) howsoever
caused, which may be suffered or incurred or which may arise directly
or indirectly in the use of the WalkyDog®.
EUROPEAN AND U.S. PATENTS PENDING.
|
